Python script to be run the octopi. Will automatically connect to the HUB and activate it, providing the information needed to communicate back. ###Preinstallation ####Octopi This api relies on Octopi and assumes you have some knowledge of it. Please visit https://github.com/guysoft/OctoPi for information on Octopi. Before installing this software you must have set up a default slicing and printer profile, along with the API-Key. ###Installation ####Requirements Must be installed on a debian based distro, ie. raspbian, ubuntu ####Instructions #####Interface The interface to use for connecting to the HUB. This will most likely be your wireless adapter, ie. wlan0 #####Config file The file to write command line configuration to. Default is recommended #####Network SSID The SSID of the Wireless Access Point that the HUB will be broadcasting. #####Network Password The password of the Wireless Access Point. #####Black Box UID The UID of the blackbox that the printerpi and printer should be plugged into. #####IP Address The IP Address of the HUB's webserver #####Port The Port of the HUB's webserver